One Entry Locksmiths Frequently Asked Question Section

Q. Can one key be used for all my entry doors?
A. Yes, you can have all your locks keyed to one key.

A locksmith, the installer, or the dealer from whom you purchase your lock will be able to advise you on this.

Steps:

Visit your local approved locksmith .
Choose the type of locks you need - the locksmith will help you with this.
The locksmith will then assemble the lock to work from just one key.
The locksmith will then fit the locks to your house.
You now have one key convenience.

Your new locks can even be keyed to work with your existing key.

Q. What can I use to clean my lock?
A.Do not use solvents or abrasive cleaners on any components as this will destroy the protective clearcoat finish and void the guarantee.
Please use a water dampened, soft cloth to remove fingerprints.
A mild soap solution applied with a soft cloth will remove oil or accumulated dirt build-up.
Note: Avoid products that state on the label that they remove tarnish and rust or that they contain acids or caustic agents.


Installation

Q. What tools will I need to install a lock?
A. Most locks require only a Phillips head screwdriver for installation.
A handleset will require a drill and drill bit in addition to the screwdriver.
Please refer to the Installation Sheet supplied with the lockset to make sure you have all the necessary tools.

Q. How do I determine the handing of a door?
A. The handing of a door is always determined by facing the exterior of a door.
- If the hinge is on the left side of the door, the door is left handed (LH).

- If the hinge is on the right side of the door, the door is right handed (RH).

When ordering a handed product, specify LH or RH. Not all products are handed; only specify handing when required.

Q. Can I install my own lock?
A. Most locks have been specially designed for ease of installation so that the average do-it-yourselfer can approach lock installation with ease.

When installing a handleset or an entry lockset and a deadbolt on the same door take the time to align the locks so that the deadbolt locks freely when the door is shut normally.
Most products come with detailed installation instructions.
NOTE: Doors with pre-drilled holes contribute to ease-of-installation. If a door is not pre-drilled, it may be prudent to have a qualified vendor or installer drill and mortise the door for you.

Still have a question? Call us 01933 353199 or 07974 744764